Enum wayland_protocols::wp::presentation_time::client::wp_presentation::Event
source · #[non_exhaustive]pub enum Event {
ClockId {
clk_id: u32,
},
}
Variants (Non-exhaustive)§
This enum is marked as non-exhaustive
ClockId
clock ID for timestamps
This event tells the client in which clock domain the compositor interprets the timestamps used by the presentation extension. This clock is called the presentation clock.
The compositor sends this event when the client binds to the presentation interface. The presentation clock does not change during the lifetime of the client connection.
The clock identifier is platform dependent. On POSIX platforms, the identifier value is one of the clockid_t values accepted by clock_gettime(). clock_gettime() is defined by POSIX.1-2001.
Timestamps in this clock domain are expressed as tv_sec_hi, tv_sec_lo, tv_nsec triples, each component being an unsigned 32-bit value. Whole seconds are in tv_sec which is a 64-bit value combined from tv_sec_hi and tv_sec_lo, and the additional fractional part in tv_nsec as nanoseconds. Hence, for valid timestamps tv_nsec must be in [0, 999999999].
Note that clock_id applies only to the presentation clock, and implies nothing about e.g. the timestamps used in the Wayland core protocol input events.
Compositors should prefer a clock which does not jump and is not slewed e.g. by NTP. The absolute value of the clock is irrelevant. Precision of one millisecond or better is recommended. Clients must be able to query the current clock value directly, not by asking the compositor.
Implementations§
Trait Implementations§
Auto Trait Implementations§
impl Freeze for Event
impl RefUnwindSafe for Event
impl Send for Event
impl Sync for Event
impl Unpin for Event
impl UnwindSafe for Event
Blanket Implementations§
source§impl<T> BorrowMut<T> for Twhere
T: ?Sized,
impl<T> BorrowMut<T> for Twhere
T: ?Sized,
source§fn borrow_mut(&mut self) -> &mut T
fn borrow_mut(&mut self) -> &mut T
source§impl<T> Downcast for Twhere
T: Any,
impl<T> Downcast for Twhere
T: Any,
source§fn into_any(self: Box<T>) -> Box<dyn Any>
fn into_any(self: Box<T>) -> Box<dyn Any>
Box<dyn Trait>
(where Trait: Downcast
) to Box<dyn Any>
. Box<dyn Any>
can
then be further downcast
into Box<ConcreteType>
where ConcreteType
implements Trait
.source§fn into_any_rc(self: Rc<T>) -> Rc<dyn Any>
fn into_any_rc(self: Rc<T>) -> Rc<dyn Any>
Rc<Trait>
(where Trait: Downcast
) to Rc<Any>
. Rc<Any>
can then be
further downcast
into Rc<ConcreteType>
where ConcreteType
implements Trait
.source§fn as_any(&self) -> &(dyn Any + 'static)
fn as_any(&self) -> &(dyn Any + 'static)
&Trait
(where Trait: Downcast
) to &Any
. This is needed since Rust cannot
generate &Any
’s vtable from &Trait
’s.source§fn as_any_mut(&mut self) -> &mut (dyn Any + 'static)
fn as_any_mut(&mut self) -> &mut (dyn Any + 'static)
&mut Trait
(where Trait: Downcast
) to &Any
. This is needed since Rust cannot
generate &mut Any
’s vtable from &mut Trait
’s.