Trait smithay_client_toolkit::seat::touch::TouchHandler

source · 
pub trait TouchHandler: Sized {
    // Required methods
    fn down(
        &mut self,
        conn: &Connection,
        qh: &QueueHandle<Self>,
        touch: &WlTouch,
        serial: u32,
        time: u32,
        surface: WlSurface,
        id: i32,
        position: (f64, f64),
    );
    fn up(
        &mut self,
        conn: &Connection,
        qh: &QueueHandle<Self>,
        touch: &WlTouch,
        serial: u32,
        time: u32,
        id: i32,
    );
    fn motion(
        &mut self,
        conn: &Connection,
        qh: &QueueHandle<Self>,
        touch: &WlTouch,
        time: u32,
        id: i32,
        position: (f64, f64),
    );
    fn shape(
        &mut self,
        conn: &Connection,
        qh: &QueueHandle<Self>,
        touch: &WlTouch,
        id: i32,
        major: f64,
        minor: f64,
    );
    fn orientation(
        &mut self,
        conn: &Connection,
        qh: &QueueHandle<Self>,
        touch: &WlTouch,
        id: i32,
        orientation: f64,
    );
    fn cancel(
        &mut self,
        conn: &Connection,
        qh: &QueueHandle<Self>,
        touch: &WlTouch,
    );
}

Required Methods§

source

fn down( &mut self, conn: &Connection, qh: &QueueHandle<Self>, touch: &WlTouch, serial: u32, time: u32, surface: WlSurface, id: i32, position: (f64, f64), )

New touch point.

Indicates a new touch point has appeared on the surface, starting a touch sequence. The ID associated with this event identifies this touch point for devices with multi-touch and will be referenced in future events.

The associated touch ID ceases to be valid after the touch up event with the associated ID and may be reused for other touch points after that.

Coordinates are surface-local.

source

fn up( &mut self, conn: &Connection, qh: &QueueHandle<Self>, touch: &WlTouch, serial: u32, time: u32, id: i32, )

End of touch sequence.

source

fn motion( &mut self, conn: &Connection, qh: &QueueHandle<Self>, touch: &WlTouch, time: u32, id: i32, position: (f64, f64), )

Touch point motion.

Coordinates are surface-local.

source

fn shape( &mut self, conn: &Connection, qh: &QueueHandle<Self>, touch: &WlTouch, id: i32, major: f64, minor: f64, )

Touch point shape change.

The shape of a touch point is approximated by an ellipse through the major and minor axis length. Major always represents the larger of the two axis and is orthogonal to minor.

The dimensions are specified in surface-local coordinates and the locations reported by other events always report the center of the ellipse.

source

fn orientation( &mut self, conn: &Connection, qh: &QueueHandle<Self>, touch: &WlTouch, id: i32, orientation: f64, )

Touch point shape orientation.

The orientation describes the clockwise angle of a touch point’s major axis to the positive surface y-axis and is normalized to the -180° to +180° range.

source

fn cancel(&mut self, conn: &Connection, qh: &QueueHandle<Self>, touch: &WlTouch)

Cancel active touch sequence.

This indicates that the compositor has cancelled the active touch sequence, for example due to detection of a touch gesture.

Object Safety§

This trait is not object safe.

Implementors§